Perfect
for adding the
Glorystar Christian Satellite Service to 1.2M, 2.4M and larger dishes
for reception in fringe reception areas.
View programming from two or three satellites with a single dish! Mount
two brackets for up to 20+ degrees of coverage without moving the dish.
Note: Most
40mm LNBFs allow reception of
satellites spaced as close as 4 degrees. Reception of multiple
satellites spaced less than 4 degrees may be possible with reduced
signal quality.
Add a GEOSATpro / Ecoda 22KHz switch, program the receiver for the additional satellite and it will instantly and seamlessly switch between channels on different satellites. Fits popular dishes including GEOSATpro, Winegard, Fortec Star, SatRadar and most other brands. Accepts any standard 40mm LNBFs (LNBF not included).
Geosynchronous communication satellites orbit the earth approximately 23,000 miles above the equator. From your install location, this arc of satellites follows a curve starting on the Eastern horizon, rising to the highest point directly South, then sloping to the Western horizon. It is important to note in dual satellite reception systems,both LNBFs must be placed in an exact position for the reflected satellite signals to be directed into the LNBF feed horns. If you are aiming at satellites located directly South of your install location, the two satellites will be located at a similar elevation. Both LNBFs will be installed at the same level and the individual LNBF Rotations (SKEW) will be set near the straight up 12 o’clock (zero) position.
When the two satellite locations are to the East or West of your install location, the two satellites will be at different elevation angles. When the install location is east of the satellite location, the offset AMC 4 LNBF bracket will be bent upwards to capture the second satellite. This angle is approximately the same as the LNBF Rotation Angle (SKEW) settings either provided with your Glorystar System or available on the internet at http://www.GeoSatFinder.com. Each individual LNBF Rotation (SKEW) is initially rotated to a positive, Counter Clock-wise (left turn), while standing in front of the dish looking into the reflector, to match the approximate LNBF rotation (SKEW) settings. Reference an angle finder or mechanical compass when bending the Offset LNBF Bracket to the specified angle.
For install locations West of the satellite location, the Offset AMC 4 LNBF bracket will be bent down and the individual LNBF Rotation is set to the negative, clockwise (right turn) position.
Download - Glorystar Adjustable Offset Bracket Installation and Aiming Guide - English (PDF)
Download
PDF Reader
© 2008 Satellite AV, LLC Not to be reproduced without permission and credits
